Technical Information

Page:   1   2   3   4   5   6   7   8   9   10   12

In this install we are using Back Roads Fabrications' billet dash insert. Since it is thicker than the stock dash insert it's necessary to allow for clearance on the fiberglass panel we are installing. With the upper piece held in place, mark each side where the dash trim meets the fiberglass panel.



Sand the marked sides of the upper fiberglass panel back to the mark you just made. This will allow clearance for the new billet dash insert once the panel is installed. If you are using the stock dash insert this step is not necessary.
Page:   1   2   3   4   5   6   7   8   9   10   12