Technical Information

Page:   1   2   3   4   5   6   7   8   9   10   11   12

Once the main panel is fitted it is time to mark and drill the holes for the panel mounting screws. Place the fiber glass panel firmly against the dash and extend the marks on the tape strips onto the fiberglass panel. The next step is to determine the location for the screw holes on each line. This is done by comparing the placement of the screw hole in the dash to placement of the panel. Once the correct placement has been determined drill the holes to fit a #6 screw.






Now the fiberglass panel can be attached to the dash with the screws that were removed from the stock cluster.
Page:   1   2   3   4   5   6   7   8   9   10   11   12